HPE Community
StoreEver Tape Storage
1753774 Members
6851 Online
108799 Solutions
New Discussion юеВ

Re: change of SCSI ID

 
Torsten.
Acclaimed Contributor

тАО07-21-2010 01:28 AM

тАО07-21-2010 01:28 AM

Re: change of SCSI ID

Normally a device file does not change on its own.
I wonder why the library is loop connected?

Is there a switch between?
Did you change the FC parameters on the library (config screen via web)?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
terry123
Regular Advisor

тАО07-28-2010 06:47 PM

тАО07-28-2010 06:47 PM

Re: change of SCSI ID

hi,

yes there is a switch in between, but nothing have been changed.

b.r.
terrytse
0 Kudos
Reply
Torsten.
Acclaimed Contributor

тАО07-28-2010 07:59 PM

тАО07-28-2010 07:59 PM

Re: change of SCSI ID

Can you please send a screenshot of the FC configuration page (web interface)?

Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.
__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.