- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreEver Tape Storage
- >
- Re: how to setup LUN scanning enabled
StoreEver Tape Storage
1752243
Members
5320
Online
108785
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-30-2006 12:47 AM
05-30-2006 12:47 AM
how to setup LUN scanning enabled
there is HP Storageworks MSL2024 tape library installed. problem is, the autochanger is only recognized as unknown medium changer in device manager. it should be fixed by setting the LUN scanning to be enabled on SCSI controller. There is Smart array 6i installed, but but no storage managment agent is installed in it. how can i change the LUN scanning to be enabled on scsi controller?
screenshot is attached
the goal is to
screenshot is attached
the goal is to
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-30-2006 02:47 AM
05-30-2006 02:47 AM
Re: how to setup LUN scanning enabled
LSI controllers, if I remenber well, you should select CTLR - C or CTRL-M at boot time, when the banner of lSI bios appear.
Usualy how to enter bios of the hba is written on the screen at boot time.
Then when inside the bios, look for lun support
Usualy how to enter bios of the hba is written on the screen at boot time.
Then when inside the bios, look for lun support
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP