skip over netbackup on SAN

[CSP_ALGERIA]

Hello all

We're facing a software error from netbackup running win2k on proliant connected to SAN . The backup dev is one MSL6060 ( to SAN ).
This software was upgraded from v 4.5 to 6.0MP4 , but it was running fine . SAN dev ,and san switchs are fine . So please :
Is there any tool to check hardware sanity
without passing through netbackup software.
Something like a HOT backup on SAN from win2k to the MSL6060 ?
One Unix system connected to our SAN , "tar" cmd run fine with no error .

Many thanks
SAM

[Rob Leadbeater · Accepted solution]

Hi Sam,

You should probably look at using Library & Tape Tools (L&TT) available here:

http://h20000.www2.hp.com/bizsupport/TechSupport/SoftwareDescription.jsp?lang=en&cc=us&prodTypeId=12169&prodSeriesId=316040&prodNameId=1849284&swEnvOID=181&swLang=8&mode=2&taskId=135&swItem=co-47085-2

to check everything is working OK.

Hope this helps,

Regards,

Rob

P.S. Remember to assign points !

[CSP_ALGERIA]

Many thanks .
I used LLT under unix . I forgot that LLT is availble on windows .