HPE Community
StoreEver Tape Storage
1752800 Members
5934 Online
108789 Solutions
New Discussion

slave init error - can't clear

 
Ayman Altounji
Valued Contributor

‎03-19-2001 04:00 PM

‎03-19-2001 04:00 PM

slave init error - can't clear

I keep getting slave init error. I know why I am getting it...because Slave option is set. The question is how do I get around this problem and set configuration as Master.........HELP.
0 Kudos
Reply
1 REPLY 1
Ayman Altounji
Valued Contributor

‎03-28-2001 04:00 PM

‎03-28-2001 04:00 PM

Re: slave init error - can't clear

Remove the plate at the back. This will allow the picker to think that the express elevator is there and then you will come up with out the error. At this time you can go into the special config menu and set unit as standalone. then you can replace plate on back
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.