- Community Home
- >
- Storage
- >
- Data Protection and Retention
- >
- StoreOnce Backup Storage
- >
- StorageWorks D2D2504i backup system
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
02-18-2013 03:29 AM - last edited on 10-05-2014 06:32 PM by Maiko-I
02-18-2013 03:29 AM - last edited on 10-05-2014 06:32 PM by Maiko-I
StorageWorks D2D2504i backup system
I am not sure this is the right forum for issues about the HP StorageWorks D2D 2504i backup system.
If it isn't, can anybody please point me to the right forum?
I need to configure an HP StorageWorks D2D 2504i backup system in a LAN where 2 HP Procurve switches host the same VLAN.
The switches are 2 for redundancy.
I configured the Network Mode as "High Availability (Link Aggregation)", assigned a unique IP address and connected each port to a different switch.
Hosts using the D2D are connected to the same VLAN on the same switches. Each host have 2 network interfaces, each connected to a different switch.
Is it the right configuration?
How can I maximize either network performance and fault tolerance?
Regards
marius
P.S. this thread has been moevd from General to Disk-Based Backup. - Hp Forum Moderator