HPE Community
StoreOnce Backup Storage
1751854 Members
5597 Online
108782 Solutions
New Discussion

VLS9000 - INIT_CA_CORE, Failed to start CA Applications, V3.0 firmware

 
Michael Scheinoha
Frequent Advisor

‎09-10-2008 07:46 AM

‎09-10-2008 07:46 AM

VLS9000 - INIT_CA_CORE, Failed to start CA Applications, V3.0 firmware

We are having a problem trying to create a new virtual library on a VLS9000 after upgrading from V2.2.0 to V3.0.0-6 firmware. We cannot create a new library, we get the errors listed in the Subject line, and the VLS says it is operating in a "Degraded" Status. At this point, our only solution is to downgrade back to firmware V2.2.0. Has anyone seen this issue with upgrading from V2.2.0 to V3.0.0-6 ?
0 Kudos
Reply
1 REPLY 1
meloni
Honored Contributor

‎04-28-2009 11:02 PM

‎04-28-2009 11:02 PM

Re: VLS9000 - INIT_CA_CORE, Failed to start CA Applications, V3.0 firmware

When you enable the Deduplication (at the moment you install the dedup licenses) the VLS start to initialize the process and this take several time. if at that moment the library is rebooted or other actions are done, the initialization process will fails and at next reboot you will get that error
http://h20000.www2.hp.com/bizsupport/TechSupport/Document.jsp?objectID=c01721910
---------------X-------------------X--------------------X----------------X--------------
If everything is under control, you are going too slow (Mario Andretti)
0 Kudos
Reply
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.