HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
StoreVirtual Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

HP DL320s Disk Uninitialized.

 
Jeff-J
Occasional Contributor

HP DL320s Disk Uninitialized.

I have an HP DL 320s running lefthand 9.5 I had an HDD fail, I replaced the HDD and the RAID array rebuilt itselft but the disk is still showing as uninitialized under the disk setup tab. When I right click on the disk all I get is view disk status or help.

I am using HP CMC 12.0 to manage the SAN. 

1 REPLY
Stor_Mort
HPE Pro

Re: HP DL320s Disk Uninitialized.

Hi Jeff-J,

Assuming it is not a monitoring fault that could be cured by restarting the CMC or the storage node, you will need to remove the node from the management group and reconfigure raid. This will reset the disk and raid set status.

You might also get that if you used a non-HPE branded part with firmware that doesn't know how to report status. DL320s is a really old system and it might be hard to find parts.

I am an HPE employee - HPE StoreVirtual Support