HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
StoreVirtual Storage
cancel
Showing results for 
Search instead for 
Did you mean: 

P4500 G2 installation

 
Anatoly Fedchik
Occasional Contributor

P4500 G2 installation

Hello,

 

could you help me, i need to configure the storage system from the scratch, is it possible to configure it without KVM through ilO/MGMT for example? is  it DHCP enabled?

 

 

5 REPLIES
Torsten.
Acclaimed Contributor

Re: P4500 G2 installation

Configure a single node?

You need a VGA screen (even ILO remote desktop) to set the networking information. That's it. Everything else has to be done from the Management console application.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
Anatoly Fedchik
Occasional Contributor

Re: P4500 G2 installation

I need to configure two nodes from remote location, is it possible? or i need direct access to the storage system through KVM when configuring for the first time?

 

Torsten.
Acclaimed Contributor

Re: P4500 G2 installation

You need to configure the IP address and NIC teaming from the local console or ILO remote console.

 

AFAIR the P4500G2 is a  DL180 G6 witout ILO, but a LO-100, not sure if remote console is enabled or not, it needs a license.


Hope this helps!
Regards
Torsten.

__________________________________________________
There are only 10 types of people in the world -
those who understand binary, and those who don't.

__________________________________________________
No support by private messages. Please ask the forum!

If you feel this was helpful please click the KUDOS! thumb below!   
a_o
Valued Contributor

Re: P4500 G2 installation

In my experience with these units, the P4500 G2 comes with ILO2, and remote control is enabled by default.

As long as you've connected the ILO port to a network with a DHCP server you should be fine.

ILO credentials are physically attached to the NSM in the form of a tag. You would obviously have to retrieve those credentials.

Anatoly Fedchik
Occasional Contributor

Re: P4500 G2 installation

Thank you!