- Community Home
- >
- Storage
- >
- Midrange and Enterprise Storage
- >
- StoreVirtual Storage
- >
- p4300 iscsi network and LAN between redundant proc...
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-02-2011 04:12 PM
08-02-2011 04:12 PM
p4300 iscsi network and LAN between redundant procurve and cisco
Hi
I'm configuring new p4300 san starter kit (2 shelf 7.2 TB), 2 new host dl380 g7 and 2 switch 2910 al for network redundancy.
The startup configuration was made by HP installation service techinician. He configure nic bounding, nics going to separete switch, virtual switch on vmware ecc ecc....and all work well "locally".
We enable flow control, spanning tree, jumbo frames, but i have some trouble. I don't know the way to connect all to our LAN, and make the p4300 (host and vm) visible in our network.
1 - The two 2910al must to have a trunk LACP between them?
2- ISCSI network and host are on same ip and vlan, but what i have to connect to our lan switch gateway (a stack catalyst 3750)??? A patch cord from HP switch1 to shelf 1 of catalyst 3750 and another patch cord from HP switch 2 and shelf 2 of catalyst 3750? Or i have to connect directly to Cisco 3750 from dl380 nics not used for iscsi?
I try to connect the 2 hp switches with and without port trunk between them as described above to our cisco 3750, but the storage and the host in vmware do errors and very slow performance.
If i shutdown one 2910al, no errors, but i don't have redundant networking.
I have to enable something on catalyst 3750? jumbo, flow control....??
It's very difficult to explain my problem :( I hope someone can answer.
Thanks in advance
Andrea
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
08-02-2011 06:02 PM
08-02-2011 06:02 PM
Re: p4300 iscsi network and LAN between redundant procurve and cisco
Please refer to Best Practices document at
http://bizsupport1.austin.hp.com/bc/docs/support/SupportManual/c01750150/c01750150.pdf