5130 HI OSPF,VRRP-E

[mozturk55]

Hi friends ,

I did not  see  any  OSPF and VRRP-E support on 5130 HI switch datasheet.

Are they supported on 5130 HI? and at least which switch series can  support these two protocols?

and another question is   : while the stack is working,can i add or remove another switch ,like cisco Online Insertion Removal(OIR)?

Thank you all.

[HP-Browniee]

Hi

I dont think the comware 5130 is a layer 3 switch. If you are looking for layer 3 capabilities you should go for 5500 or higher.

And yes you can just add or remove switches while the stack is working. That is one of the advantages of IRF : )

Kind regards

+++ If this post was usfull give it a kudo and mark it as solved : ) +++

[mozturk55]

thanks for ur feedback,

but still i did not get answer about VRRP-E support .

Is it available VRRP-E on 5500 or 5510?

[HP-Browniee]

HI

VRRP is supported on those switches yes. I'm guessing VRRP-E too, not sure. I never used it.

datasheet: https://www.hpe.com/h20195/v2/GetPDF.aspx/4AA3-8995ENW.pdf

Kind regards