1x Internet Traffic on 2X VLANs. (How to config?).

[Karl Collinson]

Afternoon All "Some help please" =0).

Have created VLAN 2 and VLAN 3 (VLAN 1 = Default).
VLAN2 for VoIP, VLAN 3 for Data.
IP routing is enabled due to Applications need to spk to VoIP server (VLAN2) from Data VLAN (VLAN3).

VLANS route and work fine.

I need to setup VLAN3 to enable users with a internet connection through 1x DSL Router.

Im unsure how? Do i need to set the gateway IP of the switch (VLAN 1) to the IP of the DSL router or is there a command to assign VLAN 3 a default Gateway (DSL Router).

Both DHCP servers point each client to the VLAN's IP for that scope to enable routing.

What IP should i assign the Router, should it be in keeping with VLAN 1\2 or 3's IP range?

Is there a static Route I need to enter?

Thank you very much,
Karl.

[Mohieddin Kharnoub · Accepted solution]

Hi

Create a Default Route pointing to this DSL router on your routing switch:

IP Route 0.0.0.0 0.0.0.0 a.b.c.d

Then, on this DSL router, if its located in Vlan3 (Data), or any other Vlan, create a static routes for other Vlans.

Example: Say you DSL router in Vlan1, then create 2 Static routes, one for Vlan2 and one for Vlan3 so pointing to the Vlan's IP on the routing switch.

Good Luck !!!

[Karl Collinson]

Thanks for that!!

The router cannot be programmed in that respect, is a cheap home\soho router..

??? >:-\

Thx,
Karl.

[Karl Collinson]

Also, even with the static Route, how will the VLAN this address is the gateway for Outbound traffic (Internet).

The Routing is not for VPN, only Internet access.

Thx,
Karl.

[Karl Collinson]

Set Gateway on VLAN1 to Routers address.
Ip route 0.0.0.0 0.0.0.0 RO.UT.ERS.IP

Set static routing on DSL router usin IE.

Thx,
Karl.