Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

2510G-48 High CPU and High Collision or drop rate on 100MBit/s Ports, SLOW

Torsten Hermann
Occasional Contributor

2510G-48 High CPU and High Collision or drop rate on 100MBit/s Ports, SLOW

Hello,

 

i want to tune my backup and i think i have a problem with the 2510G-48 Backbone Switch. Switch has static trunks to Netgears (GS724T and GS748T) for the clients. The CPU utilization is 30% (no Production in the Moment, only Backup) and high collision or drop rate on 100MBit/s Ports (ILO Ports or MSA Management Ports) and on 2 POrts where nothing is connected. Maximum Speed over this Switch is around 300MBit/s (checked with NetCPS between many different Ports, 2003 and 2008R2 Server). All Ports are set to Auto. No further configuration.

Configuration as follows:

; J9280A Configuration Editor; Created on release #Y.11.12

hostname "XXXXX"
snmp-server contact "XXXXX"
time timezone 120
trunk 1-2,13-14 Trk1 Trunk
trunk 3-4 Trk2 Trunk
trunk 5-8 Trk3 Trunk
trunk 9-12 Trk4 Trunk
ip default-gateway 192.xxxxxx
sntp server 192.xxx
timesync sntp
sntp unicast
snmp-server community "public" Operator Unrestricted
vlan 1
   name "DEFAULT_VLAN"
   untagged 15-Trk4
   ip address 192.xxxx 
   exit

fault-finder bad-driver sensitivity high
fault-finder bad-transceiver sensitivity high
fault-finder bad-cable sensitivity high
fault-finder too-long-cable sensitivity high
fault-finder over-bandwidth sensitivity high
fault-finder broadcast-storm sensitivity high
fault-finder loss-of-link sensitivity high
fault-finder duplex-mismatch-HDx sensitivity high
fault-finder duplex-mismatch-FDx sensitivity high
no stack
spanning-tree Trk1 priority 4
spanning-tree Trk2 priority 4
spanning-tree Trk3 priority 4
spanning-tree Trk4 priority 4
password manager

 

Did anyone has an idea?

Thanks

Torsten

 

 

1 REPLY
Richard Brodie_1
Honored Contributor

Re: 2510G-48 High CPU and High Collision or drop rate on 100MBit/s Ports, SLOW

If you are still running Y.11.12, I would upgrade to Y.11.35 before doing too much digging. It fixes some spurious "High Collision or drop rate" warnings, if nothing else.

 

https://h10145.www1.hp.com/downloads/SoftwareReleases.aspx?ProductNumber=J9280A