Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

2600, 2800 and series : getting SFP Part and serial number

SOLVED
Go to solution
E Halbwachs
Occasional Visitor

2600, 2800 and series : getting SFP Part and serial number

Hello,

I would like to collect part and serial number of the SFP optics we have in our various switchs (2600, 2510 and 2810 series).

Is there a way from the CLI or other means ?
I read about the 'show module' command but this exists apparently only on higher ends switches.

"show tech" doesn't show it.

Thanks in advance.

Cheers,
4 REPLIES
EckerA
Respected Contributor
Solution

Re: 2600, 2800 and series : getting SFP Part and serial number

hi,
try

sh tech tran

hth
alex
E Halbwachs
Occasional Visitor

Re: 2600, 2800 and series : getting SFP Part and serial number

Hello,

"show tech transc" is just what I needed !

Tanks a lot.

Stupid me, I didn't imagine that "sh tech" has more options.

Cheers,
Drew Redman
Valued Contributor

Re: 2600, 2800 and series : getting SFP Part and serial number

FYI the serial number collected from 'sh tech trans' is a 7 digit HP internal serial number from the GBIC. The 10 digit serial number (usually starts with 'MY') is what's needed if you contact ProCurve support. The only what that I know of to get that serial number is to look at the label on the transceiver.
Drew Redman
Valued Contributor

Re: 2600, 2800 and series : getting SFP Part and serial number

Typo: what = way