Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

4000m switches reseting themselves and loosing telnet and HTTP

Mark Lay
Occasional Visitor

4000m switches reseting themselves and loosing telnet and HTTP

Every so often today I have lost http and telnet to a few of my 10+ 4000m switches. They may reset themselves repetedly or still pass packets. But either way I don't have telnet or http access after whatever fault happens. They are all connected with mesh trunks to each other and no STP turned on.
2 REPLIES
Ron Kinner
Honored Contributor

Re: 4000m switches reseting themselves and loosing telnet and HTTP

What version of code do you have on the 4000's?

You should be running C.09.16

http://www.hp.com/rnd/software/switches.htm

Ron
Gonzo Granello
Valued Contributor

Re: 4000m switches reseting themselves and loosing telnet and HTTP

Ron is right, but more important, they should be all on the same rev. code and make sure they use the same trunk settings (like FEC to FEC etc).

Andreas
most time the day i have to mask my contempt for the a-holes in charge......