HPE Community
Switches, Hubs, and Modems
1753265 Members
5541 Online
108792 Solutions
New Discussion юеВ

5308xl Loopback interface

 
Marcus_20
Frequent Advisor

тАО08-31-2004 07:43 PM

тАО08-31-2004 07:43 PM

5308xl Loopback interface

Hi all!
Is there any way to create one or several loopback interfaces on the 5300xl?

This is needed as source ip for the OSPF process...

Best regards, Marcus
0 Kudos
3 REPLIES 3
SCOOTER
Esteemed Contributor

тАО08-31-2004 11:50 PM

тАО08-31-2004 11:50 PM

Re: 5308xl Loopback interface

Marcus,
You don't need to, and no it's not possible.
The router ID will be adv. as OSPF.

Regards,

SCOOTER
0 Kudos
Battiston gregor
Occasional Advisor

тАО09-02-2004 07:14 PM

тАО09-02-2004 07:14 PM

Re: 5308xl Loopback interface

Hi Marcus

You can configure the:
ip router-id xx.xx.xx.xx
before configuring OSPf so that it will use that ip address for the neighboring

Regards

Gregor
0 Kudos
Marcus_20
Frequent Advisor

тАО09-02-2004 08:18 PM

тАО09-02-2004 08:18 PM

Re: 5308xl Loopback interface

Thank you both for your replys!

/Marcus
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.