Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

5406zl update command

Zar1n
Occasional Visitor

5406zl update command

After enter the update command in CLI, switch reboot and not boot again.

All LED's on Management Module is On.
Power, Fault and Locator LED's is On.
Serial Console not respond.

How solve this problem ?

Sory, I'am bad known English... :(
3 REPLIES
Matt Hobbs
Honored Contributor

Re: 5406zl update command

I think the update command will reboot the switch into the bootROM. Just reset it again via the front panel or pull the power.
Ardon
Trusted Contributor

Re: 5406zl update command

ProCurve Switch 5412zl(config)# update
The device will be rebooted to Monitor ROM Console.
This will take the switch offline and allow only direct console access.
Do you want to continue [y/n]?

After this you will end up with:

Copyright (c) 1995-2005 Hewlett-Packard Company. All rights reserved.

RESTRICTED RIGHTS LEGEND

Use, duplication, or disclosure by the Government is subject to restrictions
as set forth in subdivision (b) (3) (ii) of the Rights in Technical Data and
Computer Software clause at 52.227-7013.

Hewlett-Packard Company, 3000 Hanover Street, Palo Alto, CA 94303

Enter h or ? for help.

=>

Just type "boot" after the prompt.

You will end up with:

Boot Profiles:

0. Monitor ROM Console
1. Primary firmware image
2. Secondary firmware image

Select profile (monitor): 1

Booting Primary firmware image...

Decompressing...done.

initializing...

Waiting for Speed Sense. Press twice to continue.
ProCurve Networking Engineer
Zar1n
Occasional Visitor

Re: 5406zl update command

I solve this problem.
Baud-rate on startup = 9600
When baud-rate = 11500 serial console not respond.