Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

802.1w (RSTP)

SOLVED
Go to solution
Maikel cim
Occasional Visitor

802.1w (RSTP)

Hi,

We have 2 HP ProCUrve 9308M with 7.06.04 firmware and 6 5372xl with the E08.01 firmware version. The connection mode is by 1Gbps ports, and each 5372xl is connected to both 9308M. So the 9308M are connected one to the other directly, and the 5372xl are connected to the other 5372xl-s by the 9308M. The primary root is one of the 9308M (prio 10), and the secondary is the second one (prio 20)

We configure 802.1w and while we don´t disconnect the connection between the two 9308, it seems that it works fine because we only lost 1 or two packets in a continuos ping. But if we disconnect the cable between the "two" roots, we lost about 30 packets, so as in the old STP.

Do you know if there is any problem between these type of equipment, or what can be hapenning?
2 REPLIES
Ardon
Trusted Contributor
Solution

Re: 802.1w (RSTP)

Hi Maikel,

Yes, we found this one out and it is fixed in the current E.08.01 code for the 53XX. We have a patched version for the 93XX (7.06.04L) that addresses this issue. Please shoot me your email address and I will forward the code as it is too big to post over here.

Regards, Ardon
ProCurve Networking Engineer
Maikel cim
Occasional Visitor

Re: 802.1w (RSTP)

Hi Ardon,

thanks a lot. My email address is iloiarte@comymedia.com