Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

8212, ip routing and access point

alexmanto
Occasional Contributor

8212, ip routing and access point

Dear sirs,

in the attached file you can see our network map.

Now we want to install, on each floor, some access point and create two new vlan (internet and intranet) that must remain separate between them.

As you will see below, in the master switch configuration, ip routing was enabled to allow the sharing of existing vlan.

Now these new Vlan must have different policies.

Can I ask you advice on how to update the configuration.

Thanks in advance.

***

Running configuration:

; J9091A Configuration Editor; Created on release #K.15.02.0005

hostname "CSMASTERIP128004"
module 1 type J8706A
module 2 type J8702A
module 3 type J8702A
ip default-gateway 192.168.128.1
ip routing
vlan 1
name "DEFAULT_VLAN"
untagged C1-C24
tagged A1,A3,A5,A7,A9,A11,A13,A15,A17,A19
no untagged A2,A4,A6,A8,A10,A12,A14,A16,A18,A20-A24,B1-B24
no ip address
exit
vlan 10
name "floor0"
untagged A2,A4,A6-A24,B2-B9,B16-B21,B23-B24
ip helper-address 192.168.140.10
ip address 192.168.128.4 255.255.252.0
tagged A1,A3,A5,B1
exit
vlan 11
name "floor1"
ip helper-address 192.168.140.10
ip address 192.168.132.4 255.255.252.0
tagged A7,A9,A11,A19,B1
exit
vlan 12
name "floor2"
ip helper-address 192.168.140.10
ip address 192.168.136.4 255.255.252.0
tagged A13,A15,A17,B1
exit
vlan 99
name "voip"
untagged B10-B15
ip helper-address 192.168.140.10
ip address 172.16.100.252 255.255.252.0
tagged A1,A3,A5,A7,A9,A11,A13,A15,A17,A19,B1
exit
vlan 98
name "serverfarm"
untagged B22
ip helper-address 192.168.140.10
ip address 192.168.140.4 255.255.255.0
tagged A1,A3,A5,A7,A9,A11,A13,A15,A17,A19,B1
exit
power-over-ethernet pre-std-detect
ip route 10.4.1.0 255.255.255.0 192.168.128.30
ip route 10.4.2.0 255.255.255.0 192.168.128.30
ip route 10.4.3.0 255.255.255.0 192.168.128.30
ip route 10.4.4.0 255.255.255.0 192.168.128.30
ip route 10.4.5.0 255.255.255.0 192.168.128.30
ip route 10.4.6.0 255.255.255.0 192.168.128.30
ip route 10.4.7.0 255.255.255.0 192.168.128.30
ip route 10.4.8.0 255.255.255.0 192.168.128.30
ip route 10.4.9.0 255.255.255.0 192.168.128.30
ip route 10.4.10.0 255.255.255.0 192.168.128.30
ip route 10.4.11.0 255.255.255.0 192.168.132.30
ip route 10.4.12.0 255.255.255.0 192.168.128.30
ip route 10.4.13.0 255.255.255.0 192.168.128.30
ip route 10.4.14.0 255.255.255.0 192.168.128.30
ip route 10.4.15.0 255.255.255.0 192.168.128.30
ip route 10.4.16.0 255.255.255.0 192.168.128.30
ip route 10.4.17.0 255.255.255.0 192.168.128.30
ip route 10.4.18.0 255.255.255.0 192.168.128.30
ip route 10.4.19.0 255.255.255.0 192.168.128.30
ip route 10.4.20.0 255.255.255.0 192.168.128.30
ip route 192.168.0.0 255.255.128.0 192.168.128.1
router vrrp
snmp-server community "ausl2" unrestricted
snmp-server host 192.168.140.10 community "public"
spanning-tree
spanning-tree config-name "MSTP"
spanning-tree config-revision 1
spanning-tree instance 1 vlan 10-12
spanning-tree instance 1 priority 0
spanning-tree instance 2 vlan 98 99
spanning-tree instance 2 priority 1
spanning-tree priority 0
vlan 10
vrrp vrid 10
owner
virtual-ip-address 192.168.128.4 255.255.252.0
priority 255
enable
exit
exit
vlan 11
vrrp vrid 11
owner
virtual-ip-address 192.168.132.4 255.255.252.0
priority 255
enable
exit
exit
vlan 12
vrrp vrid 12
owner
virtual-ip-address 192.168.136.4 255.255.252.0
priority 255
enable
exit
exit
vlan 98
vrrp vrid 98
backup
virtual-ip-address 192.168.140.5 255.255.255.0
enable
exit
exit
vlan 99
vrrp vrid 99
backup
virtual-ip-address 172.16.100.253 255.255.252.0
enable
exit
exit
no autorun
no dhcp config-file-update
no dhcp image-file-update
password manager