Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

A3724A management

Fred Ruffet
Honored Contributor

A3724A management

Hi,

I'm not sure where to post for this problem.

I have an A3724A FC hub to connect an HP server to its FC10 disks arrays. On the front panel, there is an RS232 connector, that I have used to set up an IP for this server. I'd like to now wether there is an interface I can use with this IP, or if it is only used to send SNMP traps.

Regards,

Fred
--

"Reality is just a point of view." (P. K. D.)
2 REPLIES
Ron Kinner
Honored Contributor

Re: A3724A management

About all you can do with the IP address appears to be Ping and SNMP. No mention of telnet in the manual and I am sure it can't be used like a DL100. Seems you are supposed to use the Fibre Channel Manager software to talk to it (no doubt through SNMP) per the manual at

http://h20000.www2.hp.com/bizsupport/CoreRedirect.jsp?targetPage=http%3A%2F%2Fh200005.www2.hp.com%2Fbc%2Fdocs%2Fsupport%2FSupportManual%2Flpg28417%2Flpg28417.pdf

Ron

Fred Ruffet
Honored Contributor

Re: A3724A management

Thanks, Ron. I was dreaming of a pretty http interface, like some exist for ethernet switches were you see stats for each ports, and so on...

I discovered recently that those hubs can be managed by EMS. I have configured, and wait for results.

Regards,

Fred
--

"Reality is just a point of view." (P. K. D.)