HPE Community
Switches, Hubs, and Modems
1752806 Members
5936 Online
108789 Solutions
New Discussion

ACL Configs

 
itian
New Member

‎01-27-2012 06:30 AM

‎01-27-2012 06:30 AM

ACL Configs

Hello,

 

I am trying to test and setup some ACL's on a switch, the current setup is:

 

Core Switch - HP ProCurve 2610-24-PWR

 

Edge Switch - HP ProCurve 2510-24

 

VLANS 5, 10, 15, 20, 25, 30

 

I want to deny access to VLAN 5 from VLAN 20 which is are client VLAN.

 

What commands do I need to input into the 2510 ProCurve?

0 Kudos
1 REPLY 1
DaveAnderson
Occasional Advisor

‎02-03-2012 10:12 AM

‎02-03-2012 10:12 AM

Re: ACL Configs

You would control traffic on the switch that routes the traffic between vlans.  Each vlan has to have an IP Address assigned (this is your layer3 boundary).  Your acl will be based on source and destination subnets, not vlans.

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.