Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

ACL Configs

itian
Occasional Visitor

ACL Configs

Hello,

 

I am trying to test and setup some ACL's on a switch, the current setup is:

 

Core Switch - HP ProCurve 2610-24-PWR

 

Edge Switch - HP ProCurve 2510-24

 

VLANS 5, 10, 15, 20, 25, 30

 

I want to deny access to VLAN 5 from VLAN 20 which is are client VLAN.

 

What commands do I need to input into the 2510 ProCurve?

1 REPLY
DaveAnderson
Occasional Advisor

Re: ACL Configs

You would control traffic on the switch that routes the traffic between vlans.  Each vlan has to have an IP Address assigned (this is your layer3 boundary).  Your acl will be based on source and destination subnets, not vlans.