Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

AP530 and PCM 2.3 network map

Bengt Sjoberg
Frequent Advisor

AP530 and PCM 2.3 network map

Since I upgraded the firmware of the AP530 and/or (I do not know when this really happened) my AP530 no longer shows up as connected to other switches in the PCM network map. They are discovered and shown on the network map but are shown without any links in the big map (all subnets). They are not shown on the subnet maps. The AP:S are used as bridges and are attached to Procurve switches in both ends. Previously they showed up in the network maps with the right connections. I enclose a picture of the network map with the 530 shown as single units without any connections.
Anyone have any ideas about this?
9 REPLIES
Mohieddin Kharnoub
Honored Contributor

Re: AP530 and PCM 2.3 network map

Hi

Try to re-discover the APs again it could resolve this issue.

Also be sure that your PCM+ server can reach all the APs before start re-discovering.

Good Luck !!!
Science for Everyone
Bengt Sjoberg
Frequent Advisor

Re: AP530 and PCM 2.3 network map

I should have added that I have tried to rediscover both the AP:s and the switches that are directly connected to the AP-s.
Bengt Sjoberg
Frequent Advisor

Re: AP530 and PCM 2.3 network map

Also all the AP:s and switches are reachable from the server.
L-O Persson
Occasional Visitor

Re: AP530 and PCM 2.3 network map

Hi,
I have the very same problem with AP530, 2800, 2600, 1800 and Procurve Manager plus B02.321.
Has anyone found solution for the problem?
cenk sasmaztin
Honored Contributor

Re: AP530 and PCM 2.3 network map

hi

you can use
pcm 2.322 version

and make 2.322 9 update

ftp://hp.com/pub/networking/software/
cenk

cenk sasmaztin
Honored Contributor

Re: AP530 and PCM 2.3 network map

Bengt Sjoberg
Frequent Advisor

Re: AP530 and PCM 2.3 network map

The update 5 was already applied three days ago. Rediscovery does not make any change. Still believe this is a bug (which I also have reported to Procurve support).
cenk sasmaztin
Honored Contributor

Re: AP530 and PCM 2.3 network map

I make last week install pcm+ costumer site
pass over any issue

they have 12 530 ap ,12 2610 switch and two 5400 switch

my advice download ftp link all update and make manuel.
cenk

cenk sasmaztin
Honored Contributor

Re: AP530 and PCM 2.3 network map

all update download directly pcm server

\Program Files\Hewlett-Packard\PNM\server\data\download\autoupdate folder

and open preferences tool make update manual
cenk