- Community Home
- >
- Networking
- >
- Legacy
- >
- Switches, Hubs, Modems
- >
- After factory reset no routing on 5308xl
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-15-2011 01:34 PM
11-15-2011 01:34 PM
Folks, I urgently need some help. Trying for hours now and tomorrow the employees are going to kill me.
After a factory reset all the configuration of an 5308xl is gone. I've never configured a managed switch before. Up to now I made myself familiar with telnet and cli in general. What I remember from earlier visits on web interface of that switch is that there was no default gateway and neither any VLAN configured. All clients are configured with the IP address of that switch as default gateway.
I have two problems now: From main subnet (192.168.100.0, switches own IP is 192.168.100.10) I can reach every host within that subnet. But I cannot access the second subnet (192.168.200.0). The second problem is that all the clients have no access to internet. Could someone please explain how to route from 100.0 to 200.0 without VLAN configuration and to route the internet traffic to our firewall (192.168.100.50)?
Summarized:
Subnet A 192.168.100.0/24
Subnet B 192.168.200.0/24
Switch 192.168.100.10
Internet-Gateway 192.168.100.50
Both subnets should "see" each other and all clients should have the switches IP as default gateway and be able to access internet.
Any help is greatly appreciated,
regards,
Stefano
Solved! Go to Solution.
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-15-2011 09:58 PM
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-15-2011 10:55 PM
11-15-2011 10:55 PM
Re: After factory reset no routing on 5308xl
Alex,
I just entered your route and immediately my Blackberry startet jingling because it is flooded with mails that stuck since yesterday evening. It seems to work - MINUTES before the first employee entered office!! You prevented me from enormous trouble.
Thanks so much for your efforts,
Stefano