Switches, Hubs, and Modems
1748230 Members
4183 Online
108759 Solutions
New Discussion юеВ

Re: Agere modem busy signal before call complete

 
Alexey_31
New Member

Agere modem busy signal before call complete

I have nx7010 with Agere softmodem. I have installed updated driver from HP and i see the following problem.
After ATDP 9951155
It is starting to call but after 99511 it is write BUSY and stop calling.
I have tryed to rollback the driver but it is not help me. Now I am returning to most updated driver and have described problem:(
4 REPLIES 4
Les Ligetfalvy
Esteemed Contributor

Re: Agere modem busy signal before call complete

Why pulse dial? Are there still systems around that don't support tone dialing?
Alexey_31
New Member

Re: Agere modem busy signal before call complete

DTMF is not supported on my PBX
Les Ligetfalvy
Esteemed Contributor

Re: Agere modem busy signal before call complete

If you are dialing out through a PBX, does that them mean the first number (9) is to get an outside line? If yes, you need to introduce a delay after it.

Try:
ATDP 9,951155

or:
ATDP 9W951155
Alexey_31
New Member

Re: Agere modem busy signal before call complete

Thanks for the help but promlem not in it.
I have found two solutions.
1.I have changed a country settings of modem from Russia to USA it is strated to dial ok but bot stable.
2.I have disabled BUSY detection. And moded working stable.
But i don't like both this solutions