HPE Community
Switches, Hubs, and Modems
1753878 Members
7145 Online
108809 Solutions
New Discussion

Brocade SAN Switch question

 
Sandy W_1
Occasional Advisor

‎06-04-2009 01:43 PM

‎06-04-2009 01:43 PM

Brocade SAN Switch question

Our SAN switch ethernet port was set to AUTO and as a result it did not properly negotiate a connection. I've run ifmodeset and hard coded to 100/full (I've run ifmodeshow to confirm). When I run configshow it displays

ether.link.mode:AUTO

Does this mean that if the switch were to reboot that it would return back to Auto?

Thanks
Sandy
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.