- Community Home
- >
- Networking
- >
- Legacy
- >
- Switches, Hubs, Modems
- >
- Re: Can't seem to ping gateway address
Switches, Hubs, and Modems
1753946
Members
7218
Online
108811
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Go to solution
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
04-20-2010 07:37 AM
04-20-2010 07:37 AM
Re: Can't seem to ping gateway address
I have not yet tested anything other than ICMP, but I am confident it applies to all IP traffic. Every ACL I have created is an IP ACL, so it should filter any and all IP traffic.
I have also found that applying this many ACLs to this many ports is a mistake. It very quickly limits the number of ACEs you can create since each ACE is calculated once per port.
I am going to have to restructure my ACLs pretty drastically so they will only be applied to the needed ports. Hopefully this will save some resources on the switch as well. I will post the final running config once that is finished, in case anyone else has a similar problem in the future.
I have also found that applying this many ACLs to this many ports is a mistake. It very quickly limits the number of ACEs you can create since each ACE is calculated once per port.
I am going to have to restructure my ACLs pretty drastically so they will only be applied to the needed ports. Hopefully this will save some resources on the switch as well. I will post the final running config once that is finished, in case anyone else has a similar problem in the future.
- « Previous
-
- 1
- 2
- Next »
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP