Cannot add a static binding for DHCP server

[dtashev]

Hello,

I recently bought HPE MSR2003 for an office router.

I created a DHCP pool and tried to enter static bindings. I used the web browser and the console interface and the result is the same. Both are not accepting a MAC address (00-04-13-31-A9-36). I tried writing it with : instead of - and the result was the same. I cannot execute the command. I also tried other MAC addresses without luck.

The command I used in the CLI was:

static-bind ip-address 192.168.0.20 hardware-address 00-04-13-31-A9-36

and it gives

wrong parameter found at ^ (pointing to the mac address)

With the web interface the result was the same, it was not accepting the MAC address.

Could this be a bug in the firmware?

Best regards,

Dobrin

[dtashev]

I found the solution on my own.

The correct format for the MAC address was: XXXX-XXXX-XXXX