Cisco Core and Procurve edge (hsrp and ospf)

[MrEdu]

I have two core cisco routers that are in an ospf area and are also setup for hsrp and ospf.

Now I am investigating procurve 3500yl at our edge sites. For the most part everything seems to work fine. However when I enable ospf on the edge(3500yl)and do a show ip route ospf I see duplicate subnets pointing to vlan ip's that are on the cisco core switches.

show ip route ospf (3500yl)
192.168.224.0/24 172.30.1.3 732 ospf External2 20 110
192.168.224.0/24 172.30.1.4 732 ospf External2 20 110
192.168.226.0/24 172.30.1.3 732 ospf External2 20 110
192.168.226.0/24 172.30.1.4 732 ospf External2 20

note
172.30.1.3 is on core 2
172.30.1.4 is on core 1

has anyone come across this or have any ideas.

Thanks!

[Patrick Terlisten]

Hello,

two cores, and two ways to one subnet. One over core 1, and the other way over core 2. What did you expect?

Best regards,
Patrick

[MrEdu]

The main problem was I did not have the stub set correctly on the core. It was passing the lsa. Once I set it to no-summary all showed correctly.