Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

Cisco Radius authentification

grisgris
Occasional Contributor

Cisco Radius authentification

Hello,

I try to link a HP switch and a Cisco ACS radius. I am looking for the Radius IEFT settings for the ACS to speak sucessfully with the HP device.
Does anyone has theses settings?

I can set the tacacs funtionnality with success but in this case i have only authentification but not authorization and accounting

Thanks

GrisGris
3 REPLIES
Azore
Occasional Visitor

Re: Cisco Radius authentification

Hi

Im in the same situation.

I've googled and looked at ciscos discussion forum but noone seems to have an answer to this.

if you get a solution grisgris, please post it here


Thanks
Mohieddin Kharnoub
Honored Contributor

Re: Cisco Radius authentification

Hi

I haven't work with the cisco ACS before, but i'm sure its pretty simple since the RADIUS is a standard based authentication service.

So what exactly the settings and configuration you need from the Cisco ACS to make it work ?

Good Luck !!!
Science for Everyone
Jiri Krystynek
Occasional Visitor

Re: Cisco Radius authentification

Hello,
I found out, that to successfull authenticate user you need to send Service-Type(6) attribute with value 6 for administrator or 7 for operator (in ACS values Administrative and NAS-PROMPT). In Cisco ACS you can use both RADIUS(Cisco IOS/PIX 6.0) and RADIUS(IETF). In User or Group setting you have to select attribude Service-Type in IETF RADIUS Attributes group.

Krystl