HPE Community
Switches, Hubs, and Modems
1752590 Members
2779 Online
108788 Solutions
New Discussion

Clear Setting on a HP 1905 switch

 
GaryMK
Occasional Contributor

‎10-03-2013 09:58 AM

‎10-03-2013 09:58 AM

Clear Setting on a HP 1905 switch

I just bought a HP v1905-48 switch. While I was testing some setting, I stupidly marked untag on all port of vlan1,

it make me unable to access the switch by web thought it's IP. Are there any other way I could clear the setting, or access it on other way?

0 Kudos
1 REPLY 1
Richard Brodie_1
Honored Contributor

‎10-03-2013 03:45 PM

‎10-03-2013 03:45 PM

Re: Clear Setting on a HP 1905 switch

There's a console port, and it should have shipped with an RJ45/DB9 console cable. 

 

 

38,400 baud (bits per second)
8 data bits
no parity
1 stop bit
no hardware flow control

 

 Apprarently "restore default" is the CLI option for a factory reset, if you can't figure out how to undo what you've done. Good luck!

The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.