Config of redundant network

[Vincent Fortier_6]

After a good night of sleep, I made changes to the drawing.

I had to add a new switch (a 3400) to allow for cheap network ports (ILO and printers)

Since I have default vlan split in multiple subnets, Link 1 and Link 2 will be tagged to default vlan.

Link 3 and link 4 will be tagged to only the shared vlans by the switch based on the floor.

Link 5 and 6 to the switch 3 on floor B, will they be on default vlan? this will create a problem isn't it?

Also, for the config of XRRP, here is part of the setup I will use:
For VLAN 4 (example), Switch B1 will have IP 10.10.4.1/24 and switch B2 10.10.4.2/24

This should take care of redundancy in case of switch failure.