HPE Community
Switches, Hubs, and Modems
1753925 Members
8884 Online
108810 Solutions
New Discussion

Re: Creating Link aggregation between 2 switches using LACP

 
Shadow13
Respected Contributor

‎05-31-2010 01:55 AM

‎05-31-2010 01:55 AM

Creating Link aggregation between 2 switches using LACP

is there any configuration changes on the switches configuration when creating LACP trunk between 2 switches using wireless bridges ?

0 Kudos
1 REPLY 1
Ralf Krause
Frequent Advisor

‎05-31-2010 10:30 PM

‎05-31-2010 10:30 PM

Re: Creating Link aggregation between 2 switches using LACP

Hi Shadow13,

not necessarily. But I would recommend to enable UniDirectional Link Detection (UDLD - "link-keepalive"), since you will not physically detect a link loss on the switch port, when the wireless signal gets stuck.

Regards,
Ralf
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.