- Community Home
- >
- Networking
- >
- Legacy
- >
- Switches, Hubs, Modems
- >
- Re: DHCP relay on 2910al
Switches, Hubs, and Modems
1753789
Members
7562
Online
108799
Solutions
Forums
Categories
Company
Local Language
back
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
back
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Blogs
Information
Community
Resources
Community Language
Language
Forums
Blogs
Topic Options
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-05-2010 02:20 AM
11-05-2010 02:20 AM
DHCP relay on 2910al
Hi guys,
I am using the HP Procurve 2910al with several VLAN's. The DHCP server and the client are in different VLAN's. To relay the DHCP request for IPv4, I use the ip-helper address. How do I relay the IPv6 request when I am using DHCPv6 on the same DHCP server? I have configured each VLAN on the 2910al and the DHCP server with both link-local and unique-local addresses.
Regards.
I am using the HP Procurve 2910al with several VLAN's. The DHCP server and the client are in different VLAN's. To relay the DHCP request for IPv4, I use the ip-helper address. How do I relay the IPv6 request when I am using DHCPv6 on the same DHCP server? I have configured each VLAN on the 2910al and the DHCP server with both link-local and unique-local addresses.
Regards.
1 REPLY 1
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
11-05-2010 06:55 AM
11-05-2010 06:55 AM
Re: DHCP relay on 2910al
At this time, IPv6 routing support is only available on the ProVision ASIC family of switches (3500,5400,6200,6600,8200) with K.15 code.
At this time, the 2910 can be an IPv6 client, but not an IPv6 router.
hth...Jeff
At this time, the 2910 can be an IPv6 client, but not an IPv6 router.
hth...Jeff
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.
News and Events
Support
© Copyright 2024 Hewlett Packard Enterprise Development LP