HPE Community read-only access December 15, 2018
This is a maintenance upgrade. You will be able to read articles and posts, but not post or reply.
Hours:
Dec 15, 4:00 am to 10:00 am UTC
Dec 14, 10:00 pm CST to Dec 15, 4:00 am CST
Dec 14, 8:00 pm PST to Dec 15, 2:00 am PST
Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

GUI access to a Brocade 300 Switch

 
dirkdevos
Frequent Advisor

GUI access to a Brocade 300 Switch

Hi,

A few days ago we had the need to make some configuration changes to our Brocade 300 Switch and when we tried to access the web page we ended got redirected to "http://jdl.sun.com/webapps/getjava/BrowserRedirect?locale=en&host=java.com” and returns a message that the page could not be found. We have tried different browsers as well as different versions of Java but to no avail.

As we were able to get in a couple of months ago something must have changed recently. Has anybody come accross this and found a work around. Any help will be greatly appreciated.

2 REPLIES
Rodrigo_Octavia
Occasional Advisor

Re: GUI access to a Brocade 300 Switch

Hello dirkdevos,

It is an older problem with brocades, I have seen many posts on other sites about this and I tell you: Try to make your changes by command line using ssh, because the webpage of this Switch has problem.

However, if you can try it, I suggest this:

1. Put the IP address of your switches in java exceptions
2. Open your windows cmd and type: javaws "http: // [your ip address of the switch] /switchExplorer_installed.html"

dirkdevos
Frequent Advisor

Re: GUI access to a Brocade 300 Switch

Hi,

I opened a ticket with support and there were a couple of firmware updates that I had to do to get it to a pont where the GUI worked.