GVRP VLAN Membership

[Christian--]

Hi! I'm trying to configure two HP switches, 2824 and 2626 to sync VLANs.

The switches are connected by Fibre (one Port). I want to use the 2824 as the master switch so I put all Ports on that one to "Block gvrp". On the 2626 the Fibre-Port is set to "Learn gvrp". I tagged two VLANs from the master switch (ID 1+2) on the Fibre Port and they can be seen on the 2626 as GVRP_1 + GVRP_2 by using "show vlan" on the CLI. On the slave switch I gave them a name and set both vlans to "tagged"-mode on the uplink port.

All of this is what I expected but when I put a Port from the 2626 in the VLAN (untagged), it does not work. Did I miss something?

[Christian--]

Ok, the port on the slave switch connecting to the master has to be set to "auto" instead of "tagged" which makes sense...

What about the master switch? "auto" or "tagged"?