Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

GbE2c blade switch management interface

rvent
Frequent Advisor

GbE2c blade switch management interface

I am trying to use image2 in the switch to try some new settings, but i am unable to get image2 working right.

Image2 was at version 2.0.0 so i upgraded it to 2.0.4 and then to 5.1.3. It boots fine, but for some reason the management interface is not present on image2.

I ask display info about layer 3 settings and it shows no interfaces. I tried to setup interface 256, but it fails when i try to add it to the management VLAN 4095.

Any ideas on how i can configure the management interface..?

Thanks