- Community Home
- >
- Networking
- >
- Legacy
- >
- Switches, Hubs, Modems
- >
- Gbic Speed switching problem on a 5406zl
Categories
Company
Local Language
Forums
Discussions
Forums
- Data Protection and Retention
- Entry Storage Systems
- Legacy
- Midrange and Enterprise Storage
- Storage Networking
- HPE Nimble Storage
Discussions
Discussions
Discussions
Forums
Discussions
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
- BladeSystem Infrastructure and Application Solutions
- Appliance Servers
- Alpha Servers
- BackOffice Products
- Internet Products
- HPE 9000 and HPE e3000 Servers
- Networking
- Netservers
- Secure OS Software for Linux
- Server Management (Insight Manager 7)
- Windows Server 2003
- Operating System - Tru64 Unix
- ProLiant Deployment and Provisioning
- Linux-Based Community / Regional
- Microsoft System Center Integration
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Discussion Boards
Community
Resources
Forums
Blogs
- Subscribe to RSS Feed
- Mark Topic as New
- Mark Topic as Read
- Float this Topic for Current User
- Bookmark
- Subscribe
- Printer Friendly Page
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-13-2013 08:45 AM
05-13-2013 08:45 AM
Gbic Speed switching problem on a 5406zl
Hi.
I am using a 5406zl - 6 port with premium software (j9642A) (firmware - 15.10.09)
Using a 24-port SFP module (J9537A)
fitted with J8177C 1Gb RJ45 SFP
The SFP is supposed to switch down to 100Mb using the command - speed-duplex auto-100.
The command returns the following message
"Value auto-100 is not applicable to port XX"
We have the exact same setup running on two identical Procurve switches (except running J8697A 5406 backplanes?) and the settings on those have succesfully been applied albeit with the 100-full setting (which doesn't work on the problem switch)
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-15-2013 06:55 AM
05-15-2013 06:55 AM
Re: Gbic Speed switching problem on a 5406zl
- Mark as New
- Bookmark
- Subscribe
- Mute
- Subscribe to RSS Feed
- Permalink
- Report Inappropriate Content
05-16-2013 05:12 AM
05-16-2013 05:12 AM
Re: Gbic Speed switching problem on a 5406zl
Thanks Scooter, that is EXACTLY the issue and the resolution... I actually found the doc about two hours ago, but I very much appreciate the reply.
Just typical... This issue has been effecting the switches for some time it would appear.