Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

HP NJ2000 - PoE clients not receiving power when connected to a CISCO 2960S

amesc
Occasional Visitor

HP NJ2000 - PoE clients not receiving power when connected to a CISCO 2960S

I have a 3Com knowledbase article, relating to PoE not being made available on ports 1 or 2 on a NJ2000 when the NJ2000 is connected to a Cisco 2960S switch, which delivers PoE+/802.3at

Is this still the situation? I have a NJ2000 upgraded to v2.00.07 software, which according to the release notes, 2.0.5 made the device compatible with more PoE switches. This reports power input is 802.3af only and the Cisco switch has been configured to run LLDP and power management related LLDP TLVs are switched off as a result of searching around and finding a support document titled "HP E-Series switches with POE+ ports do not provide PoE+ 802.3at power to Intellijack NJ2000(JD057A) by default."

1 REPLY
Mithusmagus
Occasional Visitor

Re: HP NJ2000 - PoE clients not receiving power when connected to a CISCO 2960S

I am in the same situtation. I have a number of nj2000Gs connected to 2960Ss and can't get it to pull move than 15.4 power. Have you opened up a TAC CAse with Cisco? That is my next step.