HPE Community
Switches, Hubs, and Modems
1753652 Members
6108 Online
108798 Solutions
New Discussion

HP ProCurve Series 2810 configuration

 
INVpat
Occasional Contributor

‎12-28-2009 10:55 PM

‎12-28-2009 10:55 PM

HP ProCurve Series 2810 configuration

I used to work on Cisco routers and switches.It is my first experience to configure HP switches.I would like to know as to how do I assign vlan to a specific ports and how will I assign my HP switch to a VTP or find out if it is supported?
0 Kudos
1 REPLY 1
Michael_Breuer
Esteemed Contributor

‎12-29-2009 01:43 AM

‎12-29-2009 01:43 AM

Re: HP ProCurve Series 2810 configuration

Hi,

please have a look at former threads. I.e.: http://forums13.itrc.hp.com/service/forums/questionanswer.do?threadId=1395117

VTP is not supported on Procurve.

Cheers,

Michael
Ingentive Networks GmbH
0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.