Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

HP & Motorola Canopy

Steve Warden
Occasional Visitor

HP & Motorola Canopy

Hi,

I have just installed an HP switch with NO config set yet.
All the equipment I have run so far has worked OK (NTP, CMM etc...)
This is on a WISP using CMM Micro to connect the Backhauls, Access Points etc... when I try to route the BH through the switch I lose connectivity to the unit i.e ping running to 10.0.15.xxx drops when I run through thhe switch.
(there is a link back to a CMM from one of the ports and using a Linux server on the HP I run the ping through the switch with no problem so the comms are there!)
Motorolas answer was that it must be an incompatibility issue with an ethernet compatibility. So I switche both to 100Full and I still cannot route through!
Has anybody else seen this - or am I missing something?
The unit is a 2810-24G (J9021A)
6 REPLIES
Pieter 't Hart
Honored Contributor

Re: HP & Motorola Canopy

I don't understand your config completely.
I have no knowledge of WISP, CMM, Backhauls.

But I have a question:
Do you use VLAN's in your network?

By default any switch (including HP procurve) is only aware of VLAN-1.
And all ports are configured for untagged packets in vlan-1.

It will NOT automatically detect if links with vlan-tagged packets (vlan-trunk in cisco terms) are used, and these packets will not pass the switch in default configuration.
codered10
Occasional Visitor

Re: HP & Motorola Canopy

Were you ever able to resolve this issue?  I'm running into the exact same thing and am beating my head against a wall trying to fix it.

 

Any suggestions would be much appreciated!

Naj
Valued Contributor

Re: HP & Motorola Canopy

Hi,

Are there has any radius accounting in between? how about ping side by side? it's working?

____________________________________________
:: Really appreciate if you could assign some points.
:: Don't know how to assign point? Click the KUDOS! star!
codered10
Occasional Visitor

Re: HP & Motorola Canopy

There is no accounting going on.

 

I think this is more an issue with the Canopy system as I cannot ping the radio through any switch, but I can ping it if I hook it directly to my laptop.

Naj
Valued Contributor

Re: HP & Motorola Canopy

Hi,

I have no idea on that, i had experience before which is MTROLA canopy connected to RADIUS and it's smooth no issue.. but how about if you play around with frequency in MTROLA canopy .

____________________________________________
:: Really appreciate if you could assign some points.
:: Don't know how to assign point? Click the KUDOS! star!
codered10
Occasional Visitor

Re: HP & Motorola Canopy

Frequency isn't the issue because the radios can communicate with each other.  It's just that my base radio will not communicate over ethernet through a switch.  it will only respond if hooked directly to a computer.