Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

HP5304 intervlan routing puzzler HELP PLEASE!

Brian McGaun
Occasional Visitor

HP5304 intervlan routing puzzler HELP PLEASE!

I have defined 3 vlans on an HP5304 and want to route between these vlans
The three vlans are
vlan1 192.168.0.217 255.255.255.0
vlan2 160.213.X.X 255.255.255.0 and 10.41.2.253 255.255.255.0
vlan3 192.168.96.253 255.255.252.0

I have a host on vlan2 with a 160.213.X.X address plugged into a vlan2 port which for some reason is unable to contact another host in the same vlan2 on a 10.41.2.X address???

Can someone point me in the right direction as to why this doesn't work & also have I done enough to configure inter vlan routing between these VLANS ?

I have included the routing table of the switch as well as the switch config. This was configured my my predecessor so I was unfamiliar with the initial setup



Switch Config

HP ProCurve Switch 5304XL# sho ip route

IP Route Entries

Destination Gateway VLAN Type Sub-Type Metric Dist.
------------------ --------------- ---- --------- ---------- ---------- -----
0.0.0.0/0 192.168.0.241 1 static 1 1
10.41.2.0/24 VLAN_2 2 connected 0 0
10.41.196.0/26 192.168.96.254 3 static 1 1
127.0.0.0/8 reject static 0 250
127.0.0.1/32 lo0 connected 0 0
160.213.71.0/24 VLAN_2 2 connected 0 0
192.168.0.0/24 VLAN_1 1 connected 0 0
192.168.96.0/22 VLAN_3 3 connected 0 0


Startup configuration:

; J4850A Configuration Editor; Created on release #E.08.42

hostname "HP ProCurve Switch 5304XL"
snmp-server contact
module 1 type J4820A
ip routing
snmp-server community "public" Unrestricted
vlan 1
name "VLAN_1"
untagged A1
ip address 192.168.0.217 255.255.255.0
no untagged A2-A24
exit
vlan 2
name "VLAN_2"
untagged A2-A6
ip address 160.213.X.X 255.255.255.0
ip address 10.41.2.253 255.255.255.0
exit
vlan 3
name "VLAN_3"
untagged A7-A24
ip address 192.168.96.253 255.255.252.0
exit
ip route 10.41.196.0 255.255.255.192 192.168.96.254
ip route 0.0.0.0 0.0.0.0 192.168.0.241
primary-vlan 3
spanning-tree
2 REPLIES
Matt Hobbs
Honored Contributor

Re: HP5304 intervlan routing puzzler HELP PLEASE!

The config looks right. I'd recommend you update the firmware though.

Check your clients are pointed to their right default gateways, 160.213.X.X and 10.41.2.253.

If you're using a ping test make sure the clients firewalls have been disabled if set.
Mohieddin Kharnoub
Honored Contributor

Re: HP5304 intervlan routing puzzler HELP PLEASE!

HI
Please note:
- The current 5304 version is E.10.27
Science for Everyone