Switches, Hubs, and Modems
1748094 Members
6028 Online
108758 Solutions
New Discussion юеВ

Re: HP9315 arp problem with port monitoring

 
SOLVED
Go to solution
Andrew Kargalov
New Member

HP9315 arp problem with port monitoring

Hi!

When I turn on monitoring an outgoing traffic on some port, device seemed not work with arp protocol well and it can't act as router correctly.
Mac learning and forwarding at L2 proceseed well.

My working config except passwords in attachment.

When I say my device:
conf t
int e 7/16
monitor e 3/7 output
troubles begin. Periodicaly switch lose devices on all vlans. I use the command "clear arp" for provocation.

It's remarkable, that if I use any port on slot's 11-13 as mirror all work OK.

Is it the bug in procurve software?
4 REPLIES 4
Matt Hobbs
Honored Contributor

Re: HP9315 arp problem with port monitoring

Hi Andrew,

I feel like I have also seen this issue before but didn't follow it up at the time.

You are already running the latest firmware available on the ProCurve website which is great. If you have steps to reproduce the issue I recommend you log a call with HP support.

Matt
Andrew Kargalov
New Member

Re: HP9315 arp problem with port monitoring

Hi Matt!

This issue reproduced well (with another EP managment module in the same chasis too).

Please, tell me right e-mail to contact whith HP support. There is no any "bug report" link on HP site...
Matt Hobbs
Honored Contributor
Solution

Re: HP9315 arp problem with port monitoring

It's best if you can call HP via the phone and log the call that way.

http://welcome.hp.com/country/us/en/wwcontact

Alternatively you can fill out this form:

http://www.hp.com/rnd/assistance/email.htm
Andrew Kargalov
New Member

Re: HP9315 arp problem with port monitoring

Thanks Matt! I have sent notification to HP by web-form.