HPE Community
Switches, Hubs, and Modems
1752489 Members
5543 Online
108788 Solutions
New Discussion

Isolate a group of users

 
cpwood
Occasional Visitor

‎02-09-2012 12:34 PM

‎02-09-2012 12:34 PM

Isolate a group of users

Hi

 

I am a little green in the area of VLANS and managed switch configuration and I am look for some guidance.

 

Our current LAN is built on three 1910-24Gs which are set a factory defaults. I now need to isolate a group of users on the LAN and only give them access to each other and some other common devices accessible by the other users i.e email server and internet gateway. Is this achievable with these switches and if so what would be the best way to configure them.

 

thanks in advance

Chris

 

 

0 Kudos
The opinions expressed above are the personal opinions of the authors, not of Hewlett Packard Enterprise. By using this site, you accept the Terms of Use and Rules of Participation.