Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

J3295A Config ?

SOLVED
Go to solution
Wilfrid Burel
Frequent Advisor

J3295A Config ?

Hi all

Is there a way to retrieve and/or upgrade config on a J3295A ?
I've got a lot of collision and I would like to know from which port it comes.
I don't see how to access the hub because there is no serial connection, and no way to set IP adresse. Any idea ?

Thanks
4 REPLIES
Ralph Bean_2
Trusted Contributor
Solution

Re: J3295A Config ?

Wilfred -

This is an unmanageable hub (repeater). There is no way to set an IP address, retrieve the configuration, or update the configuration.

As a troubleshooting approach for an unmanaged device, I suggest temporarily substituting a managed device. If you do not have and cannot affort to do this, then another option would be to selectively move a cable from the hub to its upstream network device, assuming that there is an upstream device, that it is manageable, and that you can find a free port on it.

Good luck.

Ralph
Wilfrid Burel
Frequent Advisor

Re: J3295A Config ?

I was afraid that there was no solution ! except putting a manageable hub or switch !

bad luck.

Thanks for your answer !
Preston Gallwas
Valued Contributor

Re: J3295A Config ?

Wilfrid, if you are to replace it with a managed device, consider a managed switch. Switches will eliminate collisions by allowing full duplex communications to each device.
Wilfrid Burel
Frequent Advisor

Re: J3295A Config ?

That's what I'll doing !

Thanks