Switches, Hubs, and Modems
1748209 Members
2743 Online
108759 Solutions
New Discussion юеВ

J4865A HP ProCurve Switch 4108GL

 
Sean_57
Occasional Contributor

J4865A HP ProCurve Switch 4108GL

I was told that there is a software package or built-in ability with the 4108 to scan the ports to find out IP addresses and computer names. Does anyone know how to accomplish this? Version info is G.07.22, ROM G.03.02. Any insight is greatly appreciated!

Regards,
Sean
4 REPLIES 4
Markku Leinio
Valued Contributor

Re: J4865A HP ProCurve Switch 4108GL

Is "show arp" command somewhere near your expectations?
Mark Landin
Valued Contributor

Re: J4865A HP ProCurve Switch 4108GL

Here's a Windows-based scanner:

http://www.angryziber.com/ipscan/

(assign points as appropriate!)
OLARU Dan
Trusted Contributor

Re: J4865A HP ProCurve Switch 4108GL

1. Fluke Network's Network Inspector does this, and many more. It's 6000 US$, though.

2. "HP Toptools for hubs and switches" is the package you might have been told about - don't install it: it'll mess-up your PC.
Stefan B Buchleitner.
Occasional Advisor

Re: J4865A HP ProCurve Switch 4108GL

Well... i se theres more than one solution to this... i would though recommend CDP (Cisco Discovery Protocol) which is supported by HP switches... only reason to use this over other solutions is to avoid third party software...

Regards
Stefan !