Email Subscription Notifications Suspended Temporarily
We are in the process of making navigation in the Servers and Operating Systems forums simpler and more direct. While doing this, we have to temporarily suspend email notifications for subscriptions. If you are subscribed to one or more discussion boards or blogs in the community, please check them daily to see new content. Notifications will be turned back on in a few days. We apologize for any inconvenience this may cause. Thanks, Warren_Admin
Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

J4903A ProCurve Switch 2824

Németh Márk
Occasional Visitor

J4903A ProCurve Switch 2824

We use an J4903A ProCurve Switch 2824.
I connect to it with telnet.
If I write "show snmp-server" it writes this:
"

Community Name MIB View Write Access
---------------- -------- ------------
public Manager Unrestricted
private Manager Restricted

Trap Receivers

Link-Change Traps Enabled on Ports [All] : All

Send Authentication Traps [No] : No

Address Community Events Sent in Trap
---------------------- ---------------- -------------------"
If I tell him "snmp-server", it writes:
"Invalid input: snmp-server"
What is the problem?

And where can I find "hpswitchauth.mib"?
2 REPLIES
Richard Brodie_1
Honored Contributor

Re: J4903A ProCurve Switch 2824

If I tell him "snmp-server", it writes:
"Invalid input: snmp-server"

You aren't in config mode.

And where can I find "hpswitchauth.mib"?
http://www.hp.com/rnd/software/MIBs.htm
Németh Márk
Occasional Visitor

Re: J4903A ProCurve Switch 2824

Yes, I also discovered. I must write "configure" and I must hit enter and voilá! :)))

I also found that link, but there is a lot of universal mibs. I thougth there is a special mib for this device.

I worked also with Moxa switches. There were special mib for that switchtype and it contains only OIDs ans traps, what the switch "knows".