Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

LACP ProCurve 2650 Release #H.10.38

João Pedro Cruz
Occasional Visitor

LACP ProCurve 2650 Release #H.10.38

I had upgrade to latest release and since this time some IP addresses got unreachable through trunk link. Nothing change since previous release, and I do not understand why with both interfaces (49-50) UP, some IP addresses are unreachable, and if I disconnect one interface, everything works fine again.

My current configuration is:

hostname "HP ProCurve Switch 2650"
snmp-server contact "Joao Pedro Cruz"
snmp-server location "Nautiradar, Lda"
broadcast-limit 20
console baud-rate 115200
interface 5
name "Phaser8400"
exit
interface 14
name "Phaser860"
exit
interface 33
name "HP3027"
exit
interface 48
name "Router"
exit
interface 49
name "Server:Trk"
no lacp
exit
interface 50
name "Server:Trk"
no lacp
exit
trunk 49-50 Trk1 LACP
ip default-gateway 192.168.0.1
sntp server 132.163.4.101
timesync sntp
sntp unicast
snmp-server community "public" Unrestricted
vlan 1
name "DEFAULT_VLAN"
untagged 1-48,Trk1
ip address 192.168.0.2 255.255.255.0
exit
no lldp run
no stack
spanning-tree Trk1 priority 4

Any comments/inputs will be most welcome!!!
1 REPLY
cenk sasmaztin
Honored Contributor

Re: LACP ProCurve 2650 Release #H.10.38

hi
I think yo make server teaming for trunk
no need for server teaming trunk
connect to team card procurve 2650 switch
occur dynamic trunk

you to want manual configuration trunk
use hp trunk

(config)#trunk 49-50 trk1 trunk
cenk