LLDP on Procurve with avaya phones

[Olaf Borowski]

You do that by specifying "voice" under the VLAN. When you do this, the switch will advertive this VLAN as the voice vlan in LLDP. But remember, earlier versions of Avaya software needed a special TLV. If you are running 2.9 or later, nothing special needs to be done, only "voice" under VLAN context.

[Era]

Does this firmware for 16xx support TLV.

ftp://ftp.avaya.com/incoming/Up1cku9/tsoweb/1600/020110/16xx_H323R1_2_2_Readme.pdf


Should I see VLAN (voice) assigned via LLDP via command


show vlan ports x ?


Regards,
Alexey

[Olaf Borowski]

Era, when the phone is connected to the switch, do a "show lldp info remote 2" (assuming phone is connected to port 2). This will tell you what the phone "thinks". Does the phone know about the voice vlan?

[Era]

It seems that it nows about Voice VLAN :

sw-ac-even(config)# show lldp info remote-device 17

LLDP Remote Device Information Detail

Local Port : 17
ChassisType : network-address
ChassisId : 0.0.0.0
PortType : mac-address
PortId : 00 1b 4f 38 2c 75
SysName : AVX382C75
System Descr :
PortDescr :

System Capabilities Supported : bridge, telephone
System Capabilities Enabled : bridge

Remote Management Address
Type : ipv4
Address : 0.0.0.0

MED Information Detail
EndpointClass :Class3
Media Policy Vlan id :200
Media Policy Priority :6
Media Policy Dscp :46
Media Policy Tagged :True
Poe Device Type :PD
Power Requested :57
Power Source :Unknown
Power Priority :High


BUT !!!!!

I can't see it in voice vlan.

sw-ac-even(config)# sh vlans ports 17

Status and Counters - VLAN Information - for ports 17

VLAN ID Name | Status Voice Jumbo
------- -------------------- + ---------- ----- -----
1 DEFAULT_VLAN | Port-based No No

Only default VLAN.

THE ONLY ONE WAY IS TO ADD IT(port to VLAN) MANUALLY?

[Olaf Borowski]

Phone thinks voice vlan is 200 and it is "tagged".

On the switch you should have:
vlan 200
tagged 17
voice

vlan xxx (datavlan)
untagged 17