Switches, Hubs, and Modems
1748032 Members
4587 Online
108757 Solutions
New Discussion юеВ

Layer 3 switching

 
Karthikeyan_5
Frequent Advisor

Layer 3 switching

Hi all

I am using 2 HP 5304 L3 switch & trying to configure OSPF routing .i need to know whether HP switch's support zero support,ifso what's the command to enable that.i tried my best it's not accepting.
3 REPLIES 3
Joaquin Gil de Vergara
Respected Contributor

Re: Layer 3 switching

i think is
# conf t

ip subnet-zero



setting OSPF is like a cisco router!
Teach is the best way to learn
Ardon
Trusted Contributor

Re: Layer 3 switching

Hi,

The IP Subnet Zero command applies to Cisco boxes or 93XX but not the 53XX. I just configured 10.10.10.1/9 (255.128.0.0) which is 1 Bit for Subnetting and the 53XX (E.07.30) accepts it. SO what range were you trying to configure? What was the error message?

Thanks, Ardon
ProCurve Networking Engineer
Karthikeyan_5
Frequent Advisor

Re: Layer 3 switching

IP-subnet zero ,i tried already but it's not picking up.even i upgraded the flash to the latest version E_07_30.

Is it advisable to use zero subnet?