Switches, Hubs, and Modems
cancel
Showing results for 
Search instead for 
Did you mean: 

MSTP on a 2824

Tim Willems
Occasional Visitor

MSTP on a 2824

Hi All,

I wanna program MSTP on a 2824

I thougth that i must use command
' span protocol-version mstp '
but there are only stp and rstp.

Is this a software or relaese problem??
And is there any solution?

Also on my 2610 it isn't possible to find the command 'protocol-version' anymore?? ideas??

Already many thx

grt
9 REPLIES
cenk sasmaztin
Honored Contributor

Re: MSTP on a 2824

hi Tim
each switch model(2824 and 2610) you make write and use this command so not see this command please update your switches



for 2824 last update I.10.43
for 2610 last update R.11.07


http://www.hp.com/rnd/software/switches.htm

cenk
cenk

Tim Willems
Occasional Visitor

Re: MSTP on a 2824

Already a great thx for your help!!

On the 2824 it is working fine now.

But on the 2610 there i don't find the commmand protocol-version
Even when i do ? after span command it isn't in the list.

And the version is R_11_07?

There is an other command 'force-version' is that an option??

Grts


cenk sasmaztin
Honored Contributor

Re: MSTP on a 2824

cenk sasmaztin
Honored Contributor

Re: MSTP on a 2824

force-version Set Spanning Tree protocol compatibility mode.

protocol-version Set Spanning Tree protocol version to use.

every two commad diffent mission

you can mstp config you must be write
protocol version command

cenk
cenk

Tim Willems
Occasional Visitor

Re: MSTP on a 2824

Hi,

In the file, you will find the help command after spanning tree command.

There he don't give the command Protocol-version.

Is that a software porblem??

Thx for the manual thats already a big help.

Grts

cenk sasmaztin
Honored Contributor

Re: MSTP on a 2824

hi
you can test pending command

spanning-tree pending < apply | config-name | config-revision | instance | reset >

and please you can read above guide (page 5-72)

cenk


cenk

cenk sasmaztin
Honored Contributor

Re: MSTP on a 2824

hi Tim
please test:
you make ago enable stp on switch
after enable protocol version command on switch

(config)#spanning-tree (enter)
(config)#spanning-tree-protocol-version mstp

cenk******
please read:
Syntax: spanning-tree-protocol-version mstp

Changes the current spanning-tree protocol on the switch to 802.1s Multiple Spanning Tree. Must be followed by write mem and reboot to activate the change. After rebooting, the switch is ready to operate as an MSTP bridge. Note that this command does not enable spanning-tree operation.

To activate the configured spanning-tree operation on the switch, execute spanning-tree.
cenk

cenk sasmaztin
Honored Contributor

Re: MSTP on a 2824

hi Tim
are you make test?
cenk

Tim Willems
Occasional Visitor

Re: MSTP on a 2824

Not yet.

I was on holidays. I will confirm you if there is a solution.

Great thx for all your info

Grt

Tim